I'm trying to use the ggstage in Grasshopper to get the relevant stages into GSA.
However, it doesn't seem to like the active elements I'm inputting. I keep getting the error message '1. Solution exception:Object reference not set to an instance of an object.' Is there a trick to getting this to work? I also can't fed the ggStageProp into GSA either?
after repairing ggRhino6Karamba1.3.1 , it shows "1. Solution exception:Unlicensed!!! To activate full functionality please request a trial license by running command ggKarambaZZLicenseRequest Run Rhino command ggKarambaZZLicenseRequest or contact Jon!"
Could you please help me to solve it? it is a little bit urgent I'm doing my Thesis project with it...many thanks!
hi, i want to transfer my rhino file in to sap2000 v20,and i'm new to sap.i found out that i should use the geometry gym plugin.so i downloaded [ggRhino6SAP20 v1.4.04.msi (31st March 2019) v20].it didn't ask me for any license during the installation.but now when i want to use the command,it says as an unknown command.what should i do?
Tina Irvine
Hi Jon,
I'm trying to use the ggstage in Grasshopper to get the relevant stages into GSA.
However, it doesn't seem to like the active elements I'm inputting. I keep getting the error message '1. Solution exception:Object reference not set to an instance of an object.' Is there a trick to getting this to work? I also can't fed the ggStageProp into GSA either?
Can you help?
Tina
Feb 6, 2019
sonia ruta
Dear Jon,
after repairing ggRhino6Karamba1.3.1 , it shows "1. Solution exception:Unlicensed!!! To activate full functionality please request a trial license by running command ggKarambaZZLicenseRequest
Run Rhino command ggKarambaZZLicenseRequest or contact Jon!"
Could you please help me to solve it? it is a little bit urgent I'm doing my Thesis project with it...many thanks!
Sonia
May 14, 2019
mahsa
hi, i want to transfer my rhino file in to sap2000 v20,and i'm new to sap.i found out that i should use the geometry gym plugin.so i downloaded [ggRhino6SAP20 v1.4.04.msi (31st March 2019) v20].it didn't ask me for any license during the installation.but now when i want to use the command,it says as an unknown command.what should i do?
thx
May 21, 2019