Grasshopper

algorithmic modeling for Rhino

Multiple loads on Karamba structural analysis model

Hi,

Probably a very simple question but how do I apply multiple loads at once to my model.

I have plugged two different loads (one point and one gravity) into my assemble. 

After Analyze > Model View > Beam View  I have two versions of simulated geometry. 

Is it possible to have these loads applied to one output?

Thanks! 

Views: 801

Attachments:

Replies to This Discussion

Permalink Reply by Matthew Tam on March 12, 2019 at 5:42am

Hi,

you need to flatten the input of the Loads input of the Assemble Model component to apply both loads to the same model. At the moment you have two "branches" which you means you have two trees.

best

Permalink Reply by Hernan Cabret on March 12, 2019 at 5:52am

Amazing thanks, very helpful!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service