Grasshopper

algorithmic modeling for Rhino

Add Beam Joint individually

Dear Karamba team,

It is possible to assign beam joints to elements individually? I need to optimize the distribution of joints and would like to set up a list of 0 and 1 integers sliders correponding to a rigid and pinned joints at the end of the beams, run galapagos with karamba and find the best way to distribute the beams along the structure.

Regards,

Màrcio

Views: 396

Replies to This Discussion

Permalink Reply by Karamba3D on August 28, 2018 at 1:18pm

Dear Márcio,

the 'Beam-Joints'-component lets you assign joints to beams based on their element identifiers. The default identifier of any element is its index. So you could generate a list of indexes, cull some members and then use it to assign joints.

Best,

Clemens

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service