Kangaroo-gHowl (Processing) - Error

Hello,

I’m working on an algorithm in Kangaroo, in order to see physical transformations and I have connected this with Processing via gHowl in order to send and receive data.

In order to run the procedure, I run the Kangaroo simulation first to receive physical forces applied (gravity, collision with surface, etc) and then run Processing algorithm. When this happens Processing is working since it runs and loops but the transformation in Rhino does not show.

When I try this without Kangaroo, this works fine and exchange information. When I also try this without processing and check the Kangaroo process, also works fine. I’m guessing the issue is the combination of Kangaroo and Processing and/or gHowl. If you have anything in mind, let me know.

Thank you!

Ifigenia