Grasshopper

algorithmic modeling for Rhino

[Voronoi] Remove outside surface

Hi everyone, 

I am struggling to remove the outside surface of this voronoi. Unlike bounding box, I cannot remove them depend on their orientation. I start to get frustrated so I started this thread with hope that someone may have faced the same problem and get sone suggestions about what to do.

Views: 902

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on March 7, 2016 at 1:57pm

"Outside" means like this?

Attachments:
Permalink Reply by Arden Nguyen on March 7, 2016 at 2:04pm

Yes! Thank you so much! I think I was over complicated myself

Permalink Reply by Zach Zhang on March 19, 2018 at 4:24pm
Genius

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service