Grasshopper

algorithmic modeling for Rhino

Voronoi+ExoWireframe = Rhino Crash

Hi everybody!

I've made this definition, using a Voronoi3D, but as soon as I connect the curves to the "L" input parameter (or I enable the Division N Slider) Rhino crash immediately. I've tried to lower all my parameters, but it crash again..

Note that if I change the BRep, for example with a simple cube, it works good.

These are the lines deriving from the Voronoi:

And this is the original BRep:

So, my question is: 
Does I've made some mistakes in my definition or is my computer too powerless?

Views: 3039

Replies to This Discussion

Permalink Reply by David Stasiuk on March 14, 2015 at 3:01pm

Hey...I don't know why it's crashing your computer, but try exploding your polylines and removing duplicates before you feed it into the Exoskeleton component. One good way to clean up your input curves is with Daniel Piker's Topologizer: http://www.grasshopper3d.com/profiles/blogs/topologizer-network-cle....

Permalink Reply by Leonardo Roli on March 15, 2015 at 4:42am

Thank you David, 

I've just tried to do what you said, adding the Topologizer component and this is the result:

Don't know if I can call it "a step forward", but at least it doesn't crash anymore.

The error says: "Solution exeption: index beyond the bounds of matrix"

Permalink Reply by Leonardo Roli on March 15, 2015 at 4:53am

I wanna say also that my goal is to design a building's structure like this one:

I want to specify because maybe there's a simpler solution to do it.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service