Grasshopper

algorithmic modeling for Rhino

Vectors at mesh (wind load)

Hi there. 

I have a 3D mesh with a number of points on. I would like to create a perpendicular vector to the mesh at each point. I use the Mesh Eval component, but somehow it misses serveral points and sets the vectors at (0,0,0) instead?

Furthermore I would like to retrieve the x-, y-, and z-component for the entire vectorfield? 

How can i do this or are there a smart way to use Karamba for wind loads as point loads at a mesh?

Regards Troels

Views: 902

Replies to This Discussion

Permalink Reply by David Rutten on April 6, 2017 at 3:13am

Can you post the mesh geometry? Either as a 3dm file or as an internalised Mesh parameter in a gh file?

Permalink Reply by Troels Meldgaard Jensen on April 6, 2017 at 3:30am

I baked the mesh and the points to make the model smaller.

The geometri comes from a larger model, which is not organized very well.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service