Ultra-paranoid mode in Grasshopper

I'm working on the development of a method to translate brep-point coordinates into a special format to send data into processing , the method itself is really simple, just exploding the brep , deconstructing the vertex points into it's coordinates and then a re- asambling the information as numbers ( coordinates ) separated by " _ " "/ " and " $" , then a I use a panel to save the data in a text document .
It has Worked With smaller models https://vimeo.com/122246273 before , but now I'm trying to use a larger model and It keeps breaking every time I plug the the panel needed to extract the data, it shows one at that point me the message that you can see in the image bellow and Then the canvas goes red and I can not continue working With The file , does anyone know where the problem could be ? and if there is any solution to it ?

Thanks in advance .

Replies to This Discussion

Permalink Reply by nikos tzar on April 28, 2015 at 3:52pm

Hello Leonardo,

I doubt you will get a solution without uploading the file in question (except maybe from David Rutten). For an alternative you can check out this component developed by Remy.

Permalink Reply by David Rutten on April 28, 2015 at 4:30pm

It means an error occurred while drawing the canvas. I'd like to get the file so I can try and find the offending component. In the meantime, try removing the paramviewer, it may be the cause.

RSS