Trim surface with projected curves.

Replies to This Discussion

Permalink Reply by max enko on October 8, 2011 at 6:25pm

Well some progress using Surface Split. 

Problem now is that i get a surface per curve trim. So it creates a new surface every time it cuts out an opening.

It does however create a single surface out of just caps.

 

Is there any way to trim openings out of just one surface using GH?

In picture, i baked the surface split output and moved one of 90 resulting surfaces to show what it does.

http://clip2net.com/clip/m0/1318119913-clip-82kb.jpg

Permalink Reply by Pieter Segeren on October 9, 2011 at 4:39am

Hi Max, did you flatten the projected curves list before putting it into the SrfSplit?

Permalink Reply by max enko on October 9, 2011 at 11:54am

Thank you so much Peter.

http://clip2net.com/clip/m0/1318182762-clip-144kb.jpg