"Surface from point" using Attractor and Graph Mapper.

Hi all,

I was trying to achieve a surface undulated using "Surface from point" where points will be unevenly distributed by curve Attractor . I am trying to achieve the surface like its seen in right side .

DOUBT.gh

I was trying to attach graph mapper to get points max. raised in z and mid of curve and less on ends.

Attachments:

d.jpg, 111 KB
DOUBT.gh, 14 KB

Replies to This Discussion

Permalink Reply by David Rutten on September 10, 2013 at 2:46am

Hi Shridhar,

It seems it bulges in the middle more than near the ends. So it's not just elevation based on closest distance to curve attractor. There's at least one other effect going on here. Perhaps the elevation is also affected by the parameter of the curve closest point, or perhaps the distance from the curve mid-point. Or maybe the curve has been divided into a large number of points and all of these points together form the new attractor.

I'm not sure but you'll have to decide which approach you want.

David Rutten

david@mcneel.com

Tirol, Austria

Permalink Reply by David Rutten on September 10, 2013 at 2:57am