Stepper Motor using HR 4988

Hello everyone,

I want to control at least 3 stepper motors using arduino uno, but still not even a single moter is moving.... i already been through all d discussions on this topic... initially i tried with easy stepper driver v4.4 then with HR 4988 Stepper module... In case of HR 4988 it works if a put a direct coad.... but in both d cases when m using firefly_Quardstepper it is not working at all.....

as @ Andy Payne Suggested in one of the discussion i changed dpin 2 and 3 to 10 and 12....

can some one plzz help me..... to sort this out...

m using arduino 1.6.9 to upload Firefly_ Quardstepper.