Grasshopper

algorithmic modeling for Rhino

square "pipe" on numerous Brep Edges

Hello,

I am trying to apply a square "pipe" onto numerous edges (over 100). Can anyone help out? I have tried sweep1 but it is too timely to place a cross section along each vertex of the edge.

Any help would be greatly appreciated. I have spent HOURS with no luck!!

Views: 2113

Attachments:

Replies to This Discussion

Permalink Reply by peter fotiadis on April 29, 2015 at 8:24am

Hi Pieter.

Well this brep yields a section like this captured (before Curve.Fit(degree,fitTol,angleTol); == kinks smaller than angleTol (angleTolerance) are smoothed).

BTW: Spot the way that Rhino does the offset Outwards thingy.

best

Permalink Reply by AdnFrs on April 29, 2015 at 3:29pm

Thank you all for the help!

This has been a very great learning experience. Still working through everything!

-A

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service