Slow definition

Replies to This Discussion

Permalink Reply by nikos tzar on March 17, 2015 at 4:38pm

Hi Maialen,

I have met some cases where it seems as if the lag comes from the graphic card's processor. This conclusion might be totally wrong but this is how it "feels" sometimes, with the definition completing calculations fast and then facing lags while zooming or orbiting in the rhino viewport.

In any case I think you can get more a accurate response if you upload the file in question.

Permalink Reply by Maialen Calleja on March 19, 2015 at 10:47am

Hi Nikos,

Thanks for your reply.

Here is the definition still going slow. If I change the patch for an edge surface it works fine but it doesn't create the right surface when the vertices aren't in the same plane, thats why i need to use the patch.

Thanks in advance,

M

Permalink Reply by nikos tzar on March 19, 2015 at 1:35pm

Maialen you didn't upload any files.

Permalink Reply by Maialen Calleja on March 19, 2015 at 1:48pm

Sorry, here is the file!

Thanks

Attachments:

• Test 001.gh, 24 KB

Permalink Reply by nikos tzar on March 19, 2015 at 3:12pm

I am sorry but I don't have any considerable lag with the definition. 

are you getting larger times?

Permalink Reply by nikos tzar on March 19, 2015 at 3:24pm

edit---

forget this post, I just saw you had already tried this....

Permalink Reply by nikos tzar on March 19, 2015 at 3:38pm

sorry for the back and forth in my replies but I must disagree:

edge surface follows the curves exactly, while patch seems to have trouble. Can you test it again?

[EdgeSrf]=green

[Curves]=yellow(-ish)

[Patch]=red

Permalink Reply by Maialen Calleja on March 20, 2015 at 4:27am

Hi Nikos,

You are right it's not the same using "Edge surface" or Patch.

-PATCH: I connect the curves plus the middle point (which IS NOT calculated with average)

              Besides I have some sayls with more than 4 edges.

-EDGE SURFACE: When the four vertices are in the same plane it should be the same solution as Patch.

I am still getting the patch really slow.

Thanks 

M