simulation of hanging cloth - anchorpoints

i am struggleing with the definition of a set of anchorpoints that are moving.

i only get three anchorpoints working but i would like to have all the yellow ones as ap.

these i would like to move. how?

thanks for your help!

henning

Attachments:

cloth.gh, 14 KB
2012-02-06_100329.jpg, 77 KB

Replies to This Discussion

Permalink Reply by David Stasiuk on February 7, 2012 at 1:20am

The problem is that your anchor points don't line up with your mesh vertices...all anchor points need to line up with the geometry/springs/forces you're using, otherwise there's nothing for them to anchor.

Attachments:

cloth_adjust.gh, 16 KB

Permalink Reply by Henning Duerr on February 8, 2012 at 6:54am

thanks david, the point with the multiple AP is clear now but it seems that the size of the cloth varies when modifying the AP even though the initial mesh is the same...??? i don´t want to formfind for each AP-setup a new cloth with a new size. i want to keep the initial cloth-size. can you help?

henning

Attachments: