Rigid Origami Simulation

Replies to This Discussion

Permalink Reply by laeti on January 31, 2013 at 3:47am

Hi,

could anyone help to solve this " error "  _wbCatmullClark ?

I am not sure whether it is kangaroo or birdweaver ?

Thank you in advance

Drag a window to zoom ( All  Dynamic  Extents  Factor  In  Out  Selected  Target  1To1 ): _Extents
Command: _wbCatmullClark
Please select meshes to apply the wbCatmullClark command to ( Level=1  NakedEdges=Smooth  Replace=Yes  KeepOnSrf=No ):
Failure in last command. The wbCatmullClark command did not complete.

Permalink Reply by David Stasiuk on January 31, 2013 at 4:11am

wb is Weaverbird.  I'm not sure why the rhino command might fail.  I do know that if your mesh topology is bad that various weaverbird components in grasshopper will fail.  Have you checked your mesh topology?

Permalink Reply by laeti on January 31, 2013 at 4:16am

thanks for your answer  *^^*

I downloaded an "already made" script from this thread

CreasePatternDeformationSimulation_Kangaroo.gh, 102 KB

I suppose the script is correct, since Lynuz Tan (see above) could use it ?

Any hint on how to solve the Weaverbird path/installation ?

thank you in advance

Permalink Reply by Andres on June 27, 2013 at 11:26pm

Hi guys, i would like to get a little bit of help here, im trying to use a origami tessellation onto a mesh

and I was thinking to use every squeare of the mesh for every fold of this pattern but to be honest Im not that good. I would like to get some guidance on this please.

here is the rhino file and thanks a lot.

Attachments:

• stand.3dm, 111 KB

Permalink Reply by Madhura Naik on February 9, 2017 at 8:42am

Hello Lynuz,

i was trying to work on a similar project for university..i would be really glad if you could share the rhino file of this definition

..

• ‹ Previous
• 1
• 2
• Next ›
• Page