Planar surface routine returned no results

Replies to This Discussion

Permalink Reply by taz on January 27, 2011 at 11:46am

You can try a couple things: 

 

1_Make sure all your curves for each surface are in their own branch.

2_Sometimes it helps to join the curves first.  If your curves wont join into a closed planar curve then [Planar Srf] wont work.

3_Since it looks like you're creating extrusions you could also try [Cap].  You may need to join all your surfaces into a BRep first.

 

If that doesn't work, your boundary is ill-defined or your curves aren't planar.

 

 

Permalink Reply by Patricia on January 28, 2011 at 12:47am

Thank you, I have tried with another geometry of closed curve and it has left me to make apply flat surface, the only one problems esque was not this the result that queria to obtain, I am seeking to do a structure,waffle as this one from a surface or a geometry, you can help me in it?

 

 

Attachments:

• duda.jpg, 995 KB
• images.jpg, 10 KB

Permalink Reply by taz on January 28, 2011 at 6:57pm

http://www.grasshopper3d.com/forum/topics/a-solid-waffle-for-laser

 

http://www.grasshopper3d.com/forum/topics/grillage-fabrication-1

Permalink Reply by Patricia on January 28, 2011 at 8:47pm

A lot of thanks you Taz, I am going to try to see, I will try to read well everything what you put, with people as it your is learned very much, thank you.

 

 

Permalink Reply by Patricia on January 29, 2011 at 3:13am

I am sorry, but not because it me does not realize the planes, besides the fact that already in the first list article gives me mistake, again , can you help me?
Not if it  will be for the language for what it is costing me, once again, thank you Taz

Attachments:

• prueba.3dm, 170 KB
• gRadFAB_v1.2.ghx, 3.4 MB