Grasshopper

algorithmic modeling for Rhino

Parallel Curves

Hi, I've been trying to set up a series of curves that are parallel to each other.  I started with a sine curve lined up to an endpoint of a line.  Using the divide component I was able to repeat the sine curve.  Is there a better way to do this with more flexible curves?  Also, the curves decrease in size as they are repeated and I would like to try keeping them the same size.  Any advice appreciated. Thanks!

 

-Bill

 

Parallellines_3.ghx

Views: 1244

Replies to This Discussion

Permalink Reply by Dedackelzucht on March 29, 2011 at 1:26am
I am not sure what you are looking for? Maybe that helps, or you could explain it with a sketch?
Attachments:
Permalink Reply by bill b on April 2, 2011 at 9:07pm

Thanks again Dedackelzucht!  

 

That's kind of what I'm getting at.  I'd like to take the sine curve and repeat it along the series of lines.  I played around with it a little bit, but haven't been able to get the result I want.  With Grasshopper I'm trying to get what is shown in the Right View window of the attached Rhino file.

-Bill 

Attachments:
Permalink Reply by Dedackelzucht on April 5, 2011 at 1:37am

Hey Bill,

 

how do you like this ones?

 

Best Regards

 

DeDackel

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service