OUT OF MEMORY- problem

Hi everyone, I am working with a project where I use Grasshopper for modelling a tunnel, a complicated one. This means ofcourse that I have used a lot of parameters and components.

Now I get some "out of memory" on nearly every kind of components. How did you guys who had similiar problems, solve or increased "the memory"?

Replies to This Discussion

Permalink Reply by Joseph Oster on November 16, 2017 at 5:55am

Keep a close eye on the output of all your components. A mistaken graft here or there can produce shocking numbers of geometry, several orders of magnitude more than expected.

Permalink Reply by Azi H on November 17, 2017 at 2:05am

I am actually divided the whole tunnel into some sections, but I am very careful with the number of points and all the outputs. Still it will be very hard to go through every component. I got this message first, and now I replaced all the merge with Weave and the Simplify tree with "right click" and choose Simplify +Flatten

But today I got the same problem again but this time is about the component Multiplication

Attachments:

2.PNG, 35 KB

Permalink Reply by Azi H on November 17, 2017 at 2:10am

Well, its basically an error message I got, I dont know so much about it, but its message saying this:

then by choosing OK, I get an other message about "Grasshopper Display error" and clicking on OK on that one too, then the Grasshopper interface or Canvas gets red.

RSS