nURBS LINE

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 7, 2017 at 12:11am

The first thing to do is to unify the curve directions and align them in order.

Attachments:

• HELP_re.gh, 10 KB

Permalink Reply by HEEN on February 7, 2017 at 12:34am

oh ! MASTER is awesome I tested it.  actually I'm trying to get a surface from polygons so I think could be better get a surface from points instead lines could you help me? 

Attachments:

• HELP1.3dm, 65 KB

Permalink Reply by Hyungsoo Kim on February 7, 2017 at 3:02am

Hey.

It is a little silly idea to try to get a decent stuff in GH using a bad data out there. It may be possible sometimes but usually it can not be a universal solution. Because it is a solution to a particular geometry.

Next time, I would like to recommend it manually in Rhino.

Attachments:

• SortCurves_re.gh, 50 KB

Permalink Reply by HEEN on February 7, 2017 at 8:44am

thank you very much! 

you save my ass!

Permalink Reply by HEEN on February 7, 2017 at 11:42am

whats happening here?

Attachments:

• failtest1.3dm, 95 KB

Permalink Reply by Hyungsoo Kim on February 7, 2017 at 12:01pm

I've already mentioned, my previous posting is not a universal solution but a solution for a particular geometry.

In this case, the subject is a mixture of tri & quad mesh, so you'll need a bit different approach.

Anyway, I'm not interested in solving these kind of problems anymore, so if you want, post a new discussion so that other forum guys can help you.

Permalink Reply by HEEN on February 7, 2017 at 12:14pm

thank you again! I appreciate it