Grasshopper

algorithmic modeling for Rhino

Need an advice on attractor point and weaverbird

Hi everyone,

I'm trying to push some points on a surface away from an attactor point and at the same time keep those points fixed on the mesh. So far the 'push' works well with weaverbird and kangaroo, but I can't figure out how to keep the points on the surface. Any advice?

Thanks!

Hanbai

Views: 399

Replies to This Discussion

Permalink Reply by Giulio Piacentino on July 3, 2012 at 4:22pm

Hi Hanbai

could you reproject the points on the surface later on?
This seems like a kangaroo question: could you try with a pull force?

Giulio

Permalink Reply by Hanbai on July 7, 2012 at 12:19pm

Hi Giulio,

I've tried to reproject the points and it works. Thanks for the help!

Hanbai

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service