mesh - surface fillet

hello! i have a mesh i produced through kangaroo and a surface below, which is let's say in my project the previous level. What i need now is to fillet the mesh with the surface. I dont know if there is such a possibility in grasshopper. i would prefer it of course in order to change the mesh and simultaneously the fillet will change. THANKSSS

Attachments:

fillet.jpg, 32 KB
fillet_help.3dm, 3.3 MB

Replies to This Discussion

Permalink Reply by Daniel Piker on September 11, 2014 at 9:38am

I see 3 possibilities:

Manually construct the fillet with extrusions or similar
Convert the mesh into a surface and use a standard fillet
Convert the surface into a mesh, and use some mesh smoothing to round the connection

For (2), see here for an example of getting relaxed NURBS from a Kangaroo mesh

For (3) I'm imagining constructing an initial flat mesh joining the 2 parts, then keeping the vertices of the top and bottom fixed, while using springs and Laplacian smoothing to round out the connecting part so tangency is preserved.

RSS