Grasshopper

algorithmic modeling for Rhino

Mesh from points Jam!!!

Hi Dudes

I want to create a mesh by using mesh from points component, however the mesh are connect to original point of my Cplane somehow. Actually I supposed to construct a mesh which some as original surface which trimmed by projected rectangle on the bigger surface. I know my word are complicated to understand, so I attached some pics and my script. Hope anyone can take a look and guide me through this.

question.ghquestion.3dm 

Views: 939

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on September 10, 2017 at 1:50pm

Hi.

Your base surface is a trimmed one, so the points fr "Divide Surface" are just a portion of the entire points of "Untrimmed Surface".  So, the number of points of U & V directions are unmatched to the division point number.

You should turn your base surface which is a trimmed surface into an untrimmed one first.

Attachments:
Permalink Reply by Ye Jin on September 11, 2017 at 8:23am

Thank you so much man，you helped me out of this trap

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service