Grasshopper

algorithmic modeling for Rhino

Mesh Edges

Hi: I was trying to run a few of the weaverbird and kangaroo examples and find, among others, that the meshedge and other similar commands are missing. Since the blocks for the missing commands don't show up in the grid I can't really begin to figure out how to replace those functions, if they are indeed missing, in order to get the function to run?

 

I began using grasshopper with 8.006 so I'm new at this.

your help is appreciated.

 

Al

 

Views: 1844

Replies to This Discussion

Permalink Reply by taz on March 24, 2011 at 9:09pm

[Mesh Edges] is from Weaverbird.

 

When you download it, it has it's own installer but (since you're using Rhino 5) you might have to load the Wb plug-in manually for Rhino 5.  Wb also has it's own R5 toolbar:

 

 

And finally in Grasshopper...

 

File > Special Folders > Components Folder... you will want to place WeaverBirdBeakCommon.gha

 

Then you will have a Wb tab in your GH ribbon:

 

 

 

 

Permalink Reply by Al Krever on March 25, 2011 at 1:20am

Got it. thanks.  Had it downloaded but not placed correctly.. Everything's operational.

much appreciated.

 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service