Grasshopper

algorithmic modeling for Rhino

loft between two surfaces

I'm trying to create ribs between two surfaces; but these ribs are "twisted".

I modified the Loft options, but the result is the same.

How can I solve this problem? I will appreciate your help. Thank you,

Views: 2175

Attachments:

Replies to This Discussion

Permalink Reply by ng5 Alex on January 9, 2017 at 5:12pm

Hello,

you need to flip one of the two curves set, before merging and then lofting.

best

alex

Permalink Reply by FLAVIO BEVILACQUA on January 9, 2017 at 6:34pm

Thank you very much Alex.

I really I appreciate your help.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service