isotrim

Replies to This Discussion

Permalink Reply by Dedackelzucht on September 5, 2012 at 2:01am

like this?

Best Regards

DeDackel

Permalink Reply by Paul Castellanos on September 5, 2012 at 3:06am

it did not work. it divides the surface by half, by each increasing integer. i can bake it and then scale1D to get the real 5' size but I want to maintain it as grasshopper geometry and not have to keep baking and relinking the baked geometry.

Attachments:

• 5feetpanels.gh, 2 KB
• 5feetpanels.3dm, 103 KB

Permalink Reply by Dedackelzucht on September 5, 2012 at 3:50am

Your input surface is a trimmed surface, this is why isotrim searchs the orignal size. just create a new surface by the edges. this is one possibility.

Best Regards

DeDackel

Permalink Reply by Paul Castellanos on September 5, 2012 at 1:55pm

I attempted to get a surface from points and it is not working the way I would like.

Attachments:

• 5feetpanels.gh, 13 KB

Permalink Reply by Paul Castellanos on September 5, 2012 at 2:08pm

nevermind. I think i got it. but i need help finding the domain for the isotrim component.

Attachments:

• 5feetpanels.gh, 6 KB

Permalink Reply by Dedackelzucht on September 6, 2012 at 2:48am

how about this one?

Best Regards

DeDackel

Attachments:

• 5feetpanels_Dedackel.gh, 6 KB

Permalink Reply by Paul Castellanos on September 6, 2012 at 4:02am

close. but I need it to grow in the Y direction by 5' as well. I tried this one but cant figure out why the perimeter panels did not divide correctly like the inner panels

Attachments:

• 5feetpanels.gh, 17 KB