Grasshopper

algorithmic modeling for Rhino

Isocontours for Daylight Autonomy

Hi!

I am trying to figure out if it is possible to show isocontours for the Daylight Autonomy analysis for the different percentages: 10, 20, 30, etc..

Is there a way, or a component that does that?

In the file attached there is an attempt where I highlighted a range of points around 50%, but I got just this far, and I do not know if there is a better way.

Thanks always for the help.

Best regards,

Federico

Views: 214

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Abraham Yezioro on August 27, 2017 at 9:40pm

I would try the LB_contourMesh component for that.

-A.

Permalink Reply by Federico on August 27, 2017 at 11:45pm

That is the one!

Thanks very much!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service