Interpolation problem

Hi, Im new in grasshopper and I was having hard time interpolating some points. As explained in the file, I ve connected in order the points for the interpolation and it worked for the first curve, however when I try to do the same thing for another curve, it will interpolate wrong, connecting the last two.

Attachments:

Captura6.PNG, 5 KB
eaeu_utdt_proVI_grupo07_protocolo disciplinar_02_sm review.3dm, 363 KB
eaeu_utdt_proVI_grupo07_protocolo disciplinar_02_sm review.gh, 30 KB

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 27, 2017 at 11:10am

Check attachment.

Attachments:

eaeu_utdt_proVI_grupo07_protocolodisciplinar_02_smreview_re.gh, 34 KB

Permalink Reply by Pag_ on August 27, 2017 at 12:56pm

Thank you very much! We really appreciate it.

Best,

P and F

Permalink Reply by Joseph Oster on August 27, 2017 at 11:38am

The sequence of points is wrong for "sendero central A", as you can see; points zero and one are reversed.

Not a good practice for point sequence to depend on how the wires are connected. Better to make that sequence explicit with a component like 'Merge':

The need for 'Flatten' on the single 'Pt (Point)' params is interesting... Without it, 'Merge' observes the disparate data paths and creates branches where you don't want them.

By the way, you can "internalize" the initial curve from Rhino in the GH file, so the Rhino file isn't needed at all. Right-click on the 'Geo' param (should be 'Crv' param) and click "Internalize data".

Permalink Reply by F L on August 27, 2017 at 12:54pm

Thank you very much! I was wondering if there was a component to create a radial array or similar so that it recreates a structure like the attachement below.

Attachments: