Grasshopper

algorithmic modeling for Rhino

how do I set these points so they are vector defined

Hello guys,

easiest question ever, I think. I try to set a group of points in rhino but I need them to look like the ones on the left. Meaning, with a plane attached to each one of them. Everything I tried resulted in the points on the right. I have tried all I could think of!

Thanks again,

Panos

Views: 224

Replies to This Discussion

Permalink Reply by nikos tzar on May 27, 2015 at 4:37am

Hello Panos,

In order to be able to see gumballs in points you need to make sure:

1. the point is internalized in Grasshopper (it is not a referenced point from rhino).

2. You have "Preferences(Ctrl+Shift+P)/Viewport/Display gumballs" selected.

3. You have the point component selected inside GH.

Permalink Reply by Panos on May 29, 2015 at 11:01am

Thank you nikos!It was quite frustrating.

regards,

Panos

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service