Grasshopper stopped working upon update of rhino 5 and gh

Hi, I've just updated my rhino 5, and when opening ugh encountered errors, so I just re-installed gh, and now it won't run at all. Comes up with these errors and then closes. Any help would be appreciated.

Thanks,

Chris

Replies to This Discussion

Permalink Reply by David Rutten on November 5, 2012 at 1:46am

You'll need to update your Rhino5 installation, it must be a very old Beta.

David Rutten

david@mcneel.com

Vienna, Austria

Permalink Reply by Chris C on November 7, 2012 at 12:35am

SOrry, I just did update it to newest Rhino 5 install before updating gh and getting this error. Any other suggestions?

Permalink Reply by Chris C on November 5, 2012 at 2:37am

I just did update it before this happened. Says it's the newest available.

Permalink Reply by Chris C on November 8, 2012 at 3:29am

Hi, it's 0.9.0014. Is that one work for this?

Thanks,

Chris

Permalink Reply by Chris C on November 8, 2012 at 10:07pm

Must have been "GH" but predictive typing changed it. My GH is now disabled on my Rhino 5 beta and won't load. Not sure what to do next... My Rhino 4 GH won't load properly either. Seems like it's a mess now and any help would be appreciated. This all just happened after updating. Any suggestions?

Permalink Reply by Chris C on November 12, 2012 at 11:21pm

Okay, I'l give all that a try and get back thank you for the help!

Permalink Reply by Chris C on November 14, 2012 at 10:31pm

I've tried one and two, still no joy. Uninstalled everything now, will try to install it again..

Permalink Reply by Chris C on November 14, 2012 at 10:47pm

Okay, I've tried all 3 methods, still nothing. Any clues what's next to get GH working again on V5? I'm unable to do any work with this out like this so any help would be appreciated.

Update, figured out it was the Goat plugin that was halting progress. In case any one else has this problem. Goat is incompatible with this version and will cause it to hang.

Thank you!

RSS