Extend Mesh Edge and Retopology

Hi everyone!! This is the first time i ask for help. Hope i don't make any mistake.

As you can see i'm trying to extend the bottom edge of a mesh i have to the boundary of a given curve.

The simplest way i had in mind was to make a loft between the edges -> convert to mesh -> Join and see i could remesh everything the find a better shape. Sadly i wasn't able to remesh it and the mesh join doesn't give a good results.

Anyone can suggest or teach me a better way? I tried to pull mesh edge with kangaroo but probably i am to noob with it.

By the way i'm using weaverbird in my def.

Thanks for your help!!

Attachments:

Mesh_Retopo_Help.gh, 288 KB

Replies to This Discussion

Permalink Reply by Daniel González Abalde on June 11, 2016 at 5:07am

This is not retopology but I think that was what you wanted.

You can use MeshMachine to remesh in the proper way (and make the retopology).

Attachments:

Mesh_Retopo_Help.gh, 575 KB

Permalink Reply by Supermonkey on June 11, 2016 at 5:21am

Yes! It sure helps! Thank you very much!!!!! I will try MeshMachine to see if a can find a smoother better shape.

Permalink Reply by Supermonkey on June 23, 2016 at 9:31am

Hi Daniel, sorry to bother you again, but i got a new problem relative to the same matter i think.
This time i'm trying to make a closed mesh, from a part of the previous one, and then join it with another mesh. The join this time is almost ok, but the problem is when i thickness the mesh: there is a way to prevent or eliminate those hideous "teeth" from the bottom?

Attachments: