Grasshopper

algorithmic modeling for Rhino

Edge Error

Hi everybody!

I'm new to Weaverbird, and I've just started to play with it.

I've found THIS tutorial, the .gh file works good, but when I've changed the original geometry (a sphere) into a brep, it happened this to the edges:

As you can see the voronoi has got a lot of error.. Maybe this is due to the fact that the definition has been written for sphere and not for a poly-surface.. 

Ideas?
Thank you all

Views: 637

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on March 5, 2015 at 9:06am

Hi. Have a try this way.

Attachments:
Permalink Reply by Leonardo Roli on March 5, 2015 at 9:19am

Wow! It seems exactly what I need.. I'll try it immediately. Many thanks!

Permalink Reply by Leonardo Roli on March 5, 2015 at 10:11am

Yep, it works perfectly! Thanks for sharing this knowledge. 

Permalink Reply by Leonardo Roli on March 6, 2015 at 8:24am

I've another question.. The definition that Hyungsoo has given to me doesn't allow to scale considerably the net. I've tried to increase the points number, but this doesn't change the things so much.. So, how to do it?

Permalink Reply by Hyungsoo Kim on March 6, 2015 at 9:10am

??

Permalink Reply by Leonardo Roli on March 6, 2015 at 9:44am

eh, eh, eh.. ok, I was increasing the points number with too low values.. Thank you again!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service