Grasshopper

algorithmic modeling for Rhino

dividing surface-rotating elements-connecting elements-make it one surface

hi everyone.

is it possible to "cut" a surface into different, not regular elements.

make every element rotate around it´s axis and then connect all elements together again? it´s almost like an accordion or a folded plate, but irregular and every element should have it´s own rotation axis.

thanks in advance!

Views: 682

Replies to This Discussion

Permalink Reply by phillip on December 19, 2012 at 7:48am

It is. And as so many times before our genius friend provides an answer.

Permalink Reply by phillip on December 19, 2012 at 9:31am

I see it´s a little hard to follow, since its a bigger, kind of unsorted definition.

So to nail down the basic idea:

You collect the single transformations and make it a compound for each step. Just like this:

Best,

Phillip

Attachments:
Permalink Reply by Hannes Löschke on December 20, 2012 at 5:53am

Check your folding lines. Some of them are polylines. RotAx can only deal with lines. Check the correct order of selection too.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service