divide surface

Hello Everyone,

I am trying to simply divide this surface by a certain length.

It´s almost ok, but i need the division to start from the central point rather than from the edge.

thank you in advance!

Attachments:

surface test.png, 219 KB

Replies to This Discussion

Permalink Reply by Dedackelzucht on September 4, 2012 at 5:30am

I tried to keep close to your start. Ther are different ways of getting this.

Best regards

DeDackel

Permalink Reply by rik on September 4, 2012 at 5:53am

thank you very much for the prompt response!
I´ll give it a try now!

Permalink Reply by rik on September 4, 2012 at 7:01am

It works perfectly on one surface, as eventually I will need to apply the whole definition to several surfaces I was now wondering if there is a way to set the first "list item" index always to the longest planar curve within the surface. This would allow me to divide all of them evenly.

thank you

Permalink Reply by Dedackelzucht on September 4, 2012 at 7:05am

- read the edge curves into the sort component (both inputs K and A)

- reverse the A output

- select 0 item

this will always be the longest egde

Best Regards

DeDackel

RSS