cull, or split tree (not too sure which) in order to get a list of points that fall within a containment curve

Thanks in advance for any help that may be provided...

I am trying to separate a grid of points to only show the ones that fall within a containment curve. Simple enough I am sure, but I cant seem to work this out. As indicated in the image, I need two lists (1's and 2's). The twos fall within the curve. The end goal is a simple attractor, so any other advice would be much appreciated.

Regards,

Clint

Attachments:

Capture.JPG, 189 KB
Containment Point Attractor.jpg, 2.7 MB

Replies to This Discussion

Permalink Reply by Michael Pryor on September 16, 2013 at 2:34pm

Use equals. Compare it to the number that represents inside. Use that data as the pattern for cull pattern component. To get the outside just inverse the pattern in the cull component by right clicking the pattern input and select inverse.

Permalink Reply by Clint Mouton on September 16, 2013 at 3:02pm