closing up the gaps between extrusions

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on October 12, 2017 at 11:57pm

Perhaps you could use my previously provided definition to easily convert a node to a mesh and give it a thickness ...

Anyway, if you do not want to use it, I will not interfere with the way you do. good luck.

Permalink Reply by julianna tong on October 13, 2017 at 12:06am

Hi, 

I was wondering where is the node coming from? would you be able to send the algorithm? 

Thank you for constantly helping :)

Permalink Reply by Hyungsoo Kim on October 13, 2017 at 12:43am

Just adding 'Purple group" in my previously provided definition.

Need "weaverbird" plug-in.

Attachments:

• Nodes_re.gh, 74 KB