Grasshopper

algorithmic modeling for Rhino

Box Morph Crash

Hi All,

I've been working on a small box morph script. I have a single brep that i'm morphing onto a surface. I've had success with the script on a smaller scale (i.e. less subdivisions on my target surface) however, I need a lot more cells for my final product than my test surfaces. I'm looking for a way to either simplify my brep geometry and or make the box morph calculation more efficient. The script stops calculating at my intended surface division count (80x80 grid = 6400 total times the script needs to morph my brep--A huge calculation I know...). Any help is appreciated! 

Views: 561

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on June 27, 2017 at 12:47pm

If you don't mind "Mesh" then, it will be helpful if you convert your base geometry fr "Brep" to "Mesh".

Attachments:
Permalink Reply by Eric Dell'Orco on June 27, 2017 at 1:29pm

Awesome! This worked perfectly. Such a simple fix! Thank you very much Hyungsoo!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service