Arrange Shapes in column

Replies to This Discussion

Permalink Reply by phillip on January 11, 2013 at 1:22am

You may need to adjust the Metaball threshold acc. to measurements of your curves.

Permalink Reply by Landscape on January 11, 2013 at 4:23am

I think that it works ... but I don't know hot to connect this to "put in column shapes algorithm" :-(

Permalink Reply by Landscape on January 11, 2013 at 7:17am

I don't know why it give me an error ...

Permalink Reply by phillip on January 11, 2013 at 8:13am

If a component turns red, you can display the RuntimeError by clicking on it. Usually it tells you what went wrong.

In this case probably s.th. like invalid search mask. This means your graft component should be a paramviewer, since you need to define a path.

Permalink Reply by Landscape on January 11, 2013 at 8:32am

Yes "Search mask was not valid: Invalid numeric element found: Referenced Polyline Curve" ... with paramviewer works, thanks a lot Phillip. Any Idea how to connect "put in column shapes algorithm"? 

Permalink Reply by Landscape on January 13, 2013 at 9:57am

Hope that U could help me!!

Permalink Reply by phillip on January 13, 2013 at 10:20am

Hard to tell what is the problem.

Please post a definition or screenshot, then me or somebody else will be happy to help.

Permalink Reply by Landscape on January 13, 2013 at 10:30am

I only need to "put in column" my group (there is an error because it puts in column every single parts)

Permalink Reply by Landscape on January 13, 2013 at 10:39am

There will be more than 2 groups 

Permalink Reply by phillip on January 13, 2013 at 11:11am

Match your inputs on the Orient.

It gets messy because you flatten at ListItem (I doubt this will always be the right point anyhow.)

Whatever comes out of this should match 

{0} 

{1} 

p.s.: I´d suggest sorting the Curve points as mentioned before (x and y). A list of 1 item always has the length of 1.

Permalink Reply by Landscape on January 13, 2013 at 11:25am

mmmm ... I tried to modify it but maybe I don't understand, I upload the GHS file if you could take a look. Thanks a lot Phillip.

Attachments:

• In column.gh, 8 KB

Permalink Reply by phillip on January 13, 2013 at 11:44am

First: Connect your curves to the sorted ones. Otherwise the effort is not worth it.

I don´t see your input curves since you do not provide them in the file (next time either internalise data or provide a rhino file with it.)

Then shift paths and your almost there.

As mentioned your points to create the array seem quite random. Look for appropriate ways of sorting your points in the forum.

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page