Applying multple lines to the "Line" parameter.

I know how to do this: right click on the "Line" parameter, then "Set Multiple Lines" and then I need to define the beginning and the end of the each line in Rhino.

But is there a way of applying multiple lines to the "Line" parameter, just by selecting all those lines in Rhino?
So instead of defining each of the line by clicking on it`s beginning and end, is there a way of just selecting them, and then the Rhino/Grasshopper will automatically recognize it`s beginning and end?

Replies to This Discussion

Permalink Reply by Stan Carroll on September 10, 2011 at 6:53am

Use the curve parameter instead of the line parameter. All lines are curves but not all curves are lines.

Stan

Permalink Reply by djordje on September 10, 2011 at 9:31am

thank you Stan!

Permalink Reply by djordje on September 11, 2011 at 9:02am

just one more question:

If particular component requests for "Line" input, does this mean that I can use "Curve" parameter instead of "Line" parameter?

Permalink Reply by djordje on September 17, 2011 at 8:18am

just one more question:

If particular component requests for "Line" input, does this mean that I can use "Curve" parameter instead of "Line" parameter?

RSS