Grasshopper

algorithmic modeling for Rhino

Adiabatic Boundary in Therm

How can I set a boundary as "Adiabatic" when setting up a therm model using Honeybee? 

Views: 311

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Chris Mackey on September 3, 2017 at 7:06pm

Apoorv,

Sorry for the late reply. Just don't assign any boundary to it and it will default to Adiabatic (as is the case in the THERM drawing interface as well).

-Chris 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service