Grasshopper

algorithmic modeling for Rhino

a quick question:

The intersection or difference between different shapes, is givving me the following result.

Is it normal to not being able to subsrtact the region in the middle of the geometry as shown in the picture? 

Views: 280

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on January 22, 2016 at 3:49am

Try to use "Boundary Surfaces" component. Best.

Permalink Reply by Florino Ita on January 22, 2016 at 4:09am

that was quick:) 

thank you

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service