Grasshopper

algorithmic modeling for Rhino

4 point surface on VB

Hello everybody,
I'm trying to write a component in VB that create a series of  4 point corner surfaces from a particular grid of point.
Is possible to implement the rhino command surface from 3 or 4 corner points in a Visual Basic Component for grasshopper?

I already found this discussion in the wiki but 
the code is written in C and i don't really know how to translate it 

thanks everybody for answer
Riccardo 

Views: 1247

Replies to This Discussion

Permalink Reply by Luis Fraguada on February 12, 2010 at 12:39pm
http://www.livearchitecture.net/archives/3409 Check out this definition for some clues...

what you are looking for will be in the functions below:
RhUtil.RhinoCreateSurfaceFromCorners(ptA, ptB, ptC, ptD)
Permalink Reply by Riccardo Bovo on February 13, 2010 at 4:20am
Thanks Luis,
i was looking exactly for that function it works perfect !

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service