Grasshopper

algorithmic modeling for Rhino

2D Geometry Sequencing

Hello everyone. 

I am relatively new to Grasshopper. I am trying to create a sequence of 2D geometry that references the geometry before it. Starting with a square, and adding one vertex per sequence. Ideally, I would be able manipulate the first in the sequence and therefore edit the full sequence. I hope this make sense. I have attached a sketch to help illustrate what I am trying to achieve. 

Any direction or help will be greatly appreciated.

Michael

Views: 277

Attachments:

Replies to This Discussion

Permalink Reply by Daniel González Abalde on December 9, 2014 at 5:49pm

You need to work with recursion / looping. There addons as hoospnake or anemone to do this, in this case, I recommend hoopsnake because you have more control of each iteration. This definition will only be a good start for you (not your goal). Enjoy it!

Attachments:
Permalink Reply by Michael Nelson on December 10, 2014 at 7:45am

Thanks Daniel!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service