perforations

Replies to This Discussion

Permalink Reply by mia on December 2, 2013 at 4:13am

i have done so much but can not mapped it into 3d surface please help!

thanku

Permalink Reply by djordje on December 2, 2013 at 4:51am

Hi Kartik,
You did not attach your image sampler photo, and more importantly the 3d surface.
Try flattening your "P" output plug at "Divide surface" component, and flattening the "F" output plug at "Surface frames" component. By "flattening" I mean: right click on it -> Flatten.

Permalink Reply by mia on December 2, 2013 at 5:01am

sorry not that one! this one .

Attachments:

• dddddddd.jpg, 4 KB
• Pattern.ghqq.gh, 32 KB

Permalink Reply by djordje on December 2, 2013 at 5:09am

I do not understand what do you want to achieve.

Try setting both X and Y domains (left click on Image sampler) to: "0 to 40" instead of "0 to 30". Is that an effect you are after?

Permalink Reply by mia on December 2, 2013 at 5:14am

no that is ok! i want to extrude them in a panel. something like in this vid. http://www.youtube.com/watch?v=iY8LBc2druE