Mix of Cull, Path Mapper and Split List

Hello,

I know this has been analyzed in other discussions, but I can't figure out how to apply in this case.

I have a list of curves, which are intersections between lists of breps. I was able to cull them in two sub-lists; now i should get rid of the first series in one list and the last series in the second list...then loft the remaining curves (just where shown by the arrows).

Grasshopper file has internalized data if somehow would like to peak inside it.

Any help would be greatly appreciated.

Capture.JPG

Capture_GH.JPG

test_VAULTS.gh

Replies to This Discussion

Permalink Reply by djordje on October 19, 2013 at 4:11am

Hi Marco,

Check the attached file.

Attachments:

test_VAULTS2.gh, 18 KB

Permalink Reply by Deriva on October 19, 2013 at 6:34am

Great job Djordje. :) I'll study your solution until I will fully understand it...it sucks being such a beginner...I spent hours on that simple task that you probably figure out in few minutes!!!

Thanks again.

Permalink Reply by djordje on October 19, 2013 at 7:14am

Try reading the Grasshopper primer first.
Also check the section on tutorials and other books from here.

RSS