Grasshopper

algorithmic modeling for Rhino

Pull Point?

Hello all

I have been away from Grasshopper for a while and as with higher math don't use it LOOSE IT and my skills have dropped

Here is what I am trying to do I have spent two day trying to get this going.  I have a rectangle shaped surface i want to pull a single point on that surface along the Z axsis the point I can move and I can move the point along the Z axsis but getting the surface to "stretch" i am lost.

Help please.

Timothy

Views: 7578

Replies to This Discussion

Permalink Reply by Timothy J. Hernacki on October 2, 2013 at 7:39pm

Thank you Vicente but it is doing nothing

Permalink Reply by Vicente Soler on October 3, 2013 at 4:17am

Have you installed Kangaroo?

Permalink Reply by Timothy J. Hernacki on October 2, 2013 at 10:47am

what is the highlighted command please?

Permalink Reply by Timothy J. Hernacki on October 2, 2013 at 11:11am

here is the basis of what I want but no sharp edges between the rectangle corners and the 'lifting point'

Permalink Reply by David Rutten on October 2, 2013 at 11:17am

I attached the file as well. It's called Patch.

--

David Rutten

david@mcneel.com

Tirol, Austria

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service