.rhi - open with?

Replies to This Discussion

Permalink Reply by Rolland MELET on July 26, 2013 at 12:11pm

Same thing for me

Please some help!! (I just re-install Rhino on my new computer running with Win8

Thx for your help

Permalink Reply by David Rutten on July 26, 2013 at 12:24pm

RHI should just run when double-clicked. If it starts Rhino instead then the file associations have been messed up. Please contact Brian Gillespie in Seattle, he's probably the only one who can fix this: brian@mcneel.com

--

David Rutten

david@mcneel.com

Tirol, Austria

Permalink Reply by Heath on August 2, 2013 at 5:37pm

Same problem here. I had to go in and tell it which program to use to open it... and it's not rhino.exe. I had to navigate to rhino 5 (64bit)>System>x64>rhiexec.exe to tell it how to open it.

Permalink Reply by Kane Borg on August 4, 2013 at 10:47am

When I choose rhiexec.exe to run the .rhi file I get an error page ;

Permalink Reply by David Rutten on August 4, 2013 at 11:56am

Please contact Brian Gillespie about this or put up a post on our discourse server.

--

David Rutten

david@mcneel.com

Tirol, Austria

Permalink Reply by Kane Borg on September 24, 2013 at 12:05pm

Yes, locating the (64bit)>System>x64>rhiexec.exe worked for me. Thanks

Permalink Reply by Dennis Bratschik on December 20, 2013 at 4:53am

Same here. Worked fine by double click, 'open with' and locating C:\Programs\Rhinoceros 5\system\x64\rhiexec.exe

Permalink Reply by raja thomas on December 23, 2013 at 6:38am

had the same problem, found link to solution on the grasshopper download page (after you click download). http://wiki.mcneel.com/rhino/5/rhi-problems

Permalink Reply by Niko on April 8, 2014 at 4:29am

guys hi

just followed all the procedure below in previous posts.

yet in rhino Command bar typing Grasshopper

it cannot find it.

Any idea/help is very welcomed

Niko

Permalink Reply by Brian Gillespie on April 8, 2014 at 10:26am

Please try this:

1. Close Rhino 5
2. Open Programs and Features from control panel.
3. Right-click Rhinoceros 5.0 SR8, then click Repair
4. Double-click the Grasshopper installer to install it again.
5. Start Rhino 5

Do you see Grasshopper now?