addition on length

Hi all, as being new in grasshopper i am trying to figure out basic mathematical problems, here is one.. I would like to divide a curve into non equal segments. In every segment i would like to add a specific increased value so the final result to be something like:

1st segment 30cm+1cm, second 30cm+2cm, third 30cm+3cm etc.. Is this possible?

Replies to This Discussion

Permalink Reply by David Rutten on September 19, 2013 at 4:29am

Yup. This is one way:

David Rutten

david@mcneel.com

Tirol, Austria

Attachments:

CurveDivide.gh, 22 KB

Permalink Reply by argeo on September 19, 2013 at 5:43am

thank you David, that was very helpfull..

I am using what you gave me on a curve, i extruded and got some contours from it and i am trying to add some extra so to be able to construct a brick wall on that logic, i think i am pretty close but i am stuck in 2 basic issues...a) how to get every second point in z axis? and b) how to get boxes oriented on the contoured curves?

do you mind having a look on what i am trying to create?

Permalink Reply by argeo on September 19, 2013 at 5:44am

and here is what i have since now..

Attachments: