The Non-Uniform Scale component is duplicating/ triplicating my geometry

Hi, I can't figure out why the Non-Uniform Scale component is duplicating/ triplicating my geometry. I am trying to make a brick wall with an attractor curve that changes the depth of each brick (and for that I am using the SCALE NU). Does someone have an idea about what is going on?

Attachments:

teste11_duvida.3dm, 30 KB
teste11_duvida.gh, 51 KB

Replies to This Discussion

Permalink Reply by David Stasiuk on July 28, 2013 at 2:03am

It's a data matching issue. It looks like your bricks are split out into two groups, each of alternating rows. Then you combine these into a geometry component which you flatten and use to calculate the attractor...but then you try to match these data back up against only one set of your bricks, which retains its data structure. If anything, you should just combine your two brick data sets and have that same output feed everything downstream. Don't bother to flatten it...the data structure will allow for all of the operations to stay correctly constrained, and you'll have the same number of bricks coming out that went in.

Permalink Reply by andrea macruz on July 29, 2013 at 8:52pm

Hi David,

Thank you very much for your answer....got it! I needed to graft the boxes and finding the centroids with the area before using as a base plane for the scale NU.

RSS