remove curves from surface?

I have a 3D voronoi box, and i've offset the faces. i'd like to remove the offset from the face. how on earth do i do this? i've tried the project component and scx component but it gives weird results.

Attachments:

Take 2.gh, 8 KB

Replies to This Discussion

Permalink Reply by Steve on July 5, 2013 at 6:59pm

in case i'm not being clear, i would like this structure to be more of a skeleton rather than solid faces

Permalink Reply by Luis Oscar Osio on July 20, 2013 at 1:10pm

hi steve.....

this is what u need...??

Attachments:

Take2.gh, 14 KB

Permalink Reply by Steve on July 22, 2013 at 7:25pm

hi luis - thank you very very much, this is what i wanted to do! i've never used the graft command, so that's also very useful.

thank you!

Permalink Reply by Steve on July 24, 2013 at 6:55am

hi again!

i have a new question open for discussion. lets say i use this new/improved definition and create a nice big box with a ton of voronoi cells in it.

now let's say i want all the cells that are in the middle of box to be closed, so that's there's a continuous 'barrier' splitting the box in half (or as close to in half as possible, i realize that this barrier will have a bunch of angles to it and won't be exactly in the middle).

see the attached terrible paint drawing to better understand what i want. pretend if i were to pour water into the top of the box, i want this barrier to fully prevent the bottom half from getting wet.

any ideas on what components i need to be using? thank you!

Attachments: