PLANE TANGENT TO MULTIPLE SPHERES.

Hi Dear Grasshopper Users;

I am just wondering how I can generate a plane which is tangent to more than two spheres?

Thanks

Replies to This Discussion

Permalink Reply by Firat Aydin on June 16, 2013 at 3:22am

thnx daniel, but b4 being able to using your response i must effort Rhino V5 then install new service release of grasshopper. I think new grasshopper is not working with Rhino4. Thanks for your attention!

Permalink Reply by Pieter Segeren on June 15, 2013 at 1:03pm

here's what I put together earlier today/my two cents. One more angle to look at it:)

Attachments:

3_Spheres_Tangent_Surface_PSG.gh, 29 KB

Permalink Reply by Firat Aydin on June 16, 2013 at 3:19am

thank you peter for your care but like other helps, your gh definition is not working properly - even giving error messages. its because i cannot install new grasshopper. i am still using rh4. i think new GH version is only for rhino 5.

Thnx

Permalink Reply by Pieter Segeren on June 16, 2013 at 3:45am

I see, well here is the HRimage from the definition.

Attachments: